select
navigate
switch tabs
Esc close

3D Printing with Aluminum

0
4

Hello everyone! Does anyone know what is the minimum wall thickness for printing a 3D part in AlSi10Mg aluminum?

Automatically translated from: Français
See original
Solved by Manon Bouriaud

Hello! Yes, for AlSi10Mg aluminum, the minimum wall thickness we recommend is 0.4 mm, with support structures. Without a support structure, then we recommend a thickness of 0.5 mm to maintain the structural integrity of the part. However, this can vary depending on the machine and the specific printing conditions.

    • Hello everyone! Does anyone know what is the minimum wall thickness for printing a 3D part in AlSi10Mg aluminum?
      Automatically translated from: Français

      See original
      0
    • Senior Content Manager

      Hello! Yes, for AlSi10Mg aluminum, the minimum wall thickness we recommend is 0.4 mm, with support structures. Without a support structure, then we recommend a thickness of 0.5 mm to maintain the structural integrity of the part. However, this can vary depending on the machine and the specific printing conditions.

      0
      Reply
      • Manon Bouriaud

        Is 0.4 mm or 0.5 mm sufficient for all applications?

        0
        Reply
    • Senior Content Manager
      Zimonix

      It’s sufficient to maintain structural integrity under normal conditions. But if your piece is intended for applications where it will be subjected to high mechanical stresses, I would recommend increasing the wall thickness to reinforce the robustness, for example to 1 mm or more, depending on your specific needs.

      0
      Reply
    • Manon Bouriaud

      Thank you very much for these clarifications!

      0
      Reply
3D Printing with Aluminum
Your information:




Suggested Topics

Topic
Replies
Views
Activity
Fastener size choice for a through-hole in 4 mm anodized aluminum plate
Hi! Designing a lightweight enclosure for a small UAV component, using 4 mm thick anodized aluminum sheets. For the assembly, I need to fasten this plate to a 3D-printed ABS bracket underneath, which acts as... read more
K
0
16
May 30
Cracking at snap-fit hook base in SLS PA12
Hello everyone, I'm using SLS 3D printing (PA12, 0.12 mm layer height) to create a snap-fit enclosure for a handheld sensor device. The enclosure has three internal hooks that flex about 1.5 mm during... read more
F
A
1
38
May 26
Choosing sheet metal thickness for a lightweight bracket
Hey, working on a small mounting bracket for a consumer electronics housing, cut and bent from stainless steel sheet (304 or 316). The part needs to stay under 200g, but it also has to... read more
D
M
1
49
May 23
Visibility of parting line on GF30 PA6 injection molded handle
Hello everyone, how visible can the parting line be on final molded parts? My team is currently designing a handle cover for an industrial machine, injection molded in PA6 with 30% glass fiber. Aesthetics... read more
T
C
1
69
May 06
Minimum embossed text size for TPU molding
Hey there, I'm designing a flexible watch strap that will be injection molded in TPU (Shore 85A). I want to include some small embossed text (branding and serial number) directly on the strap, but... read more
A
n
2
121
May 05