Europe 
Türkiye 
United Kingdom 
Global 
Login with my Xometry account H7/g6 fit - is it too tight for manual assembly?
N
Hi, I’m using a limits-and-fits guide to spec a bearing housing. I’m looking at an H7/g6 fit for a sliding location, but this is a field-repaired unit. If I go that tight, is some tech with a hammer going to destroy it in the field? Should I open it up to a looser clearance fit, or will that cause too much “slop” over time?
Suggested Topics
Topic
Replies
Views
Activity
Improving heat-set insert retention in FDM-printed ABS brackets
Hey! I have FDM-printed ABS bracket for an industrial sensor mount that’s fixed to aluminum frame using M4 screws. The part sees light vibration and occasional re-torquing during maintenance. I’m considering switching from self-tapping... read more
1
69
Mar 19
stainless steel bolts with brass inserts for a plastic intake manifold
hello, I’m redesigning an intake manifold joint on an IC engine where the upper and lower manifolds are plastic, and the factory setup uses M6 class 8.8 screws threading directly into plastic bosses. The... read more
1
167
Feb 24
Selecting the Molding Process for a GSXR 1000 Half-handlebar
Hello, I am currently working on the design/manufacture of a half-handlebar for a sports motorcycle (GSXR 1000). What is the best type of process that I could establish for the manufacture of the handlebar... read more
1
263
Feb 19
Laser cutting pc panels for machine safety enclosures
Hi, I’m producing clear polycarbonate panels for a machine safety enclosure, cut from 4 mm sheet with small mounting holes and tight internal radii. Optical clarity and edge integrity matter more than cosmetics. From... read more
2
509
Feb 20
Printing a 3D Model Purchased from a Third Party
Hello, I was wondering if there would be any issues in requesting the production of a print from a model purchased from a third party.Thank you and keep up the good work! read more
4
1.3k
Jan 23