Maximum Part Size

490 × 200 × 391 mm

Minimum Part Size

3 × 2 × 1 mm

General Tolerance

0.1%

±0.1 mm (±0.005″ ) for the first 25 mm (0.984″) is typical, plus ±0.05 mm (0.020″) for each additional 25 mm (0.984″). Tolerances may change depending on part geometry.

Minimum Feature Size

1.2 mm

• Rigid materials: 1.2 mm
• Rubber-like materials: 2 mm or greater

• Rigid materials: 0.047″
• Rubber-like materials: 0.079″ or greater

Minimal wall thickness (Supported)

1 mm

• Capability: 1.0 mm
• Recommendation: 1.5 mm

• Capability: 0.040″
• Recommendation: 0.060″

Minimal wall thickness (Unsupported)

1 mm

• Capability: 1.0 mm
• Recommendation: 1.5 mm

• Capability: 0.040″
• Recommendation: 0.060″

Maximum Wall Thickness

12.7 mm

Minimum Gap Between Walls

0.5 mm

• Capability: 0.5 mm
• Recommendation: 1.0 mm

• Capability: 0.020″
• Recommendation: 0.040″

Minimum Hole Diameter at 1mm Thickness

0.5 mm

• Capability: 0.5 mm
• Recommendation: 1.0 mm

• Capability: 0.020″
• Recommendation: 0.040″

Minimum Shaft Diameter at 1mm Height

0.5 mm

• Capability: 0.5 mm
• Recommendation: 1.5 mm

• Capability: 0.020″
• Recommendation: 0.060″

Minimum Embossed Text Height

0.5 mm

Embossed text shallower than 0.5 mm may be unclear.

Embossed text shallower than 0.020” may be unclear.

Minimum Debossed Text Depth

0.5 mm

Debossed text shallower than 0.5 mm may be unclear.

Debossed text shallower than 0.020” may be unclear.

Minimum Font Size (Character Height)

1 mm

• Capability: 1.0 mm
• Recommendation: 2.0 mm

• Capability: 0.040″
• Recommendation: 0.080″

Requires Support Structures

Yes

Horizontal Bridges, Maximum Unsupported Length

N/A

Support material is required for all types of overhangs.

Support material is required for all types of overhangs.

Maximum Unsupported Overhang Size

N/A

Support material is required for all types of overhangs.

Support material is required for all types of overhangs.

Unsupported Angle from Vertical

N/A

Support material is required for all types of overhangs. Consider accessibility of supports for removal in your design.

Minimum Clearance for Moving Parts

0.5 mm

Clearances smaller than 0.5 mm may result in fused parts.

Clearances smaller than 0.020″ may result in fused parts.

Standard Layer Thickness

0.04 mm

Infill Options

Solid