select
navigate
switch tabs
Esc close

Choosing sheet metal thickness for a lightweight bracket

0
D
2

Hey, working on a small mounting bracket for a consumer electronics housing, cut and bent from stainless steel sheet (304 or 316). The part needs to stay under 200g, but it also has to hold a static load of ~25 N without noticeable deflection over a 60 mm span. I’m debating between 0.8 mm and 1.2 mm thickness—0.8 mm meets weight targets better, but I’m unsure about stiffness and whether it will deform over time. Anyone with experience on similar parts? Am I pushing it too far with 0.8 mm?

    • D

      Hey, working on a small mounting bracket for a consumer electronics housing, cut and bent from stainless steel sheet (304 or 316). The part needs to stay under 200g, but it also has to hold a static load of ~25 N without noticeable deflection over a 60 mm span. I’m debating between 0.8 mm and 1.2 mm thickness—0.8 mm meets weight targets better, but I’m unsure about stiffness and whether it will deform over time. Anyone with experience on similar parts? Am I pushing it too far with 0.8 mm?

      0
    • M

      I’ve dealt with similar setups before. The main concern with going 0.8 mm is stiffness—it might not fail structurally, but if it flexes too much, it can feel flimsy or cheap to users. Going up to 1.2 mm adds stiffness, sure, but you can often get better results by incorporating ribs or buttresses. They add a lot of rigidity with minimal weight gain.

      Do you have some flexibility in your specs or cost targets for adding stiffening features? If you’re producing in the hundreds, using standard press brake methods (rather than custom tooling) can keep costs down more than people usually expect. With smart design, there’s a good chance you can make 0.8 mm work without sacrificing performance or perceived quality.

      0
      Reply
      • D
        Mattias

        OK, that is helpful. I’ll try some of your ideas.

        0
        Reply
Choosing sheet metal thickness for a lightweight bracket
Your information:




Cancel

Suggested Topics

Topic
Replies
Views
Activity
SLA wall thickness issue for microfluidic channels
Hi, I created a 3D design for a small microfluidic part using SLA (Clear Resin) with internal channels ~0.4 mm wide and wall thickness around 0.5 mm. The function relies on optical inspection through... read more
B
c
1
75
Jul 29
Embossed vs. engraved text for outdoor molded parts
Hi there, I need to add a part number and recycling symbol on the surface of molded parts in PP GF20 for outdoor use. I initially planned to use engraved text for aesthetic reasons,... read more
T
R
A
3
139
Aug 08
Minimum hole diameter vs sheet thickness 316L
Hello, I would like to produce a stainless steel 316L bracket, 3 mm thick, cut by fiber laser. I need to include several small holes for drainage and fastening, and I’ve heard there might... read more
F
A
3
138
Aug 01
Ejector pin placement near snap-fit
I’m working on a small injection-molded housing for an automotive sensor, using PA6 GF30. There are two snap-fit arms inside (cantilever type), about 2 mm-thick walls. I’m not sure where to place the ejector... read more
M
T
5
252
Jul 18
Adding countersinks to formed stainless sheet metal
Hello, I'm working on a sheet metal enclosure (as in the image) that requires flush mounting for M6 countersunk screws. I need to add a countersink on a few holes, but the part is... read more
D
M
D
2
154
Jul 03