select
navigate
switch tabs
Esc close

Wall thicknesses for SLA (100 mm high) - any tips?

0
K
2

Hi everyone,

I am working on an SLA 3D printing project with parts where my internal walls that need to be about 100 mm in height. Looking for advice on the optimal wall thickness to avoid warping and internal stress. What’s the minimum recommended thickness for such a wall? Any specific experiences or other guidelines would be greatly appreciated!

Solved by Nikolaus Mroncz
Dear Kris.Mel, thanks for your question. In SLA we recommend a wall thickness of min 0.6mm for unsupportive walls. More information you can find here:   https://xometry.pro/en-eu/articles/3d-printing-sla-design-tips/ https://xometry.pro/en-tr/articles/3d-printing-design-rules/
    • K

      Hi everyone,

      I am working on an SLA 3D printing project with parts where my internal walls that need to be about 100 mm in height. Looking for advice on the optimal wall thickness to avoid warping and internal stress. What’s the minimum recommended thickness for such a wall? Any specific experiences or other guidelines would be greatly appreciated!

      0
    • Xometry Engineer

      Dear Kris.Mel,

      thanks for your question.

      In SLA we recommend a wall thickness of min 0.6mm for unsupportive walls.

      More information you can find here:

       

      Stereolithography (SLA) 3D Printing Design Tips

      Infographic: Design Rules for 3D Printing

      0
      Reply
      • K
        Nikolaus Mroncz

        Thank you, that’s helpful!

        0
        Reply
Wall thicknesses for SLA (100 mm high) – any tips?
Your information:




Suggested Topics

Topic
Replies
Views
Activity
Ejector pin placement near snap-fit
I’m working on a small injection-molded housing for an automotive sensor, using PA6 GF30. There are two snap-fit arms inside (cantilever type), about 2 mm-thick walls. I’m not sure where to place the ejector... read more
M
T
5
15
Jul 18
Adding countersinks to formed stainless sheet metal
Hello, I'm working on a sheet metal enclosure (as in the image) that requires flush mounting for M6 countersunk screws. I need to add a countersink on a few holes, but the part is... read more
D
M
D
2
65
Jul 03
Fastener size choice for a through-hole in 4 mm anodized aluminum plate
Hi! Designing a lightweight enclosure for a small UAV component, using 4 mm thick anodized aluminum sheets. For the assembly, I need to fasten this plate to a 3D-printed ABS bracket underneath, which acts as... read more
K
e
E
3
137
Jun 30
Cracking at snap-fit hook base in SLS PA12
Hello everyone, I'm using SLS 3D printing (PA12, 0.12 mm layer height) to create a snap-fit enclosure for a handheld sensor device. The enclosure has three internal hooks that flex about 1.5 mm during... read more
F
A
2
152
Jun 24
Choosing sheet metal thickness for a lightweight bracket
Hey, working on a small mounting bracket for a consumer electronics housing, cut and bent from stainless steel sheet (304 or 316). The part needs to stay under 200g, but it also has to... read more
D
M
2
188
Jun 24