Hey all, my part needs to have perforated text on a thin PLA sheet, and the text is 0.4 mm thick. Do you think that’s wide enough to print cleanly without running into issues like weak layers or gaps? Or should I bump up the thickness a bit? The text width in the Y and Z axes is 0.4 mm and it perforates a thin wall, and the perforated thin wall is the first layer.
0.4mm text in PLA
A
Suggested Topics
Topic
Replies
Views
Activity
Printed bracket cracking – how to reinforce?
Hi, I'm prototyping a small bracket for holding a plastic cover in place—roughly 60 × 30 × 10 mm, with two hooks and two screw holes (M3) on the top side. I printed it in PLA with 20% infill... read more
0
55
Will a 6mm dowel fit in this hole?
hello, I'm designing a part with an FDM 3D printed hole to hold a 6mm wooden dowel, but I’m unsure about the actual fit due to print tolerances and material shrinkage. The hole is... read more
0
125