Europe 
Türkiye 
United Kingdom 
Global 
Login with my Xometry account 0.4mm text in PLA
A
Hey all, my part needs to have perforated text on a thin PLA sheet, and the text is 0.4 mm thick. Do you think that’s wide enough to print cleanly without running into issues like weak layers or gaps? Or should I bump up the thickness a bit? The text width in the Y and Z axes is 0.4 mm and it perforates a thin wall, and the perforated thin wall is the first layer.
-
-
Hey all, my part needs to have perforated text on a thin PLA sheet, and the text is 0.4 mm thick. Do you think that’s wide enough to print cleanly without running into issues like weak layers or gaps? Or should I bump up the thickness a bit? The text width in the Y and Z axes is 0.4 mm and it perforates a thin wall, and the perforated thin wall is the first layer.
-
Suggested Topics
Topic
Replies
Views
Activity
Teeth shearing off, what is the best material?
Hello, we have this small tool used to loosen/tighten a metal slotted ferrule. The teeth of the tool engage with the slots in the ends of the ferrule and torque is applied to tighten... read more
0
143
Ejector pin placement near snap-fit
I’m working on a small injection-molded housing for an automotive sensor, using PA6 GF30. There are two snap-fit arms inside (cantilever type), about 2 mm-thick walls. I’m not sure where to place the ejector... read more
0
935
Adding countersinks to formed stainless sheet metal
Hello, I'm working on a sheet metal enclosure (as in the image) that requires flush mounting for M6 countersunk screws. I need to add a countersink on a few holes, but the part is... read more
0
539
Printed bracket cracking – how to reinforce?
Hi, I'm prototyping a small bracket for holding a plastic cover in place—roughly 60 × 30 × 10 mm, with two hooks and two screw holes (M3) on the top side. I printed it in PLA with 20% infill... read more
0
617
Will a 6mm dowel fit in this hole?
hello, I'm designing a part with an FDM 3D printed hole to hold a 6mm wooden dowel, but I’m unsure about the actual fit due to print tolerances and material shrinkage. The hole is... read more
0
999