Software for designing injection molds

0

M

MatteoF

18.06.2024 at 11:46

1

I’m new to the world of injection mold design and have been tasked with creating molds for a series of consumer electronics enclosures. I have experience with Autodesk Inventor, but I’m looking for a software solution that simplifies the mold design process, ideally able to automatically determine the positions of the ejection pins and design the entire mold base based on the part’s geometry. What is the most suitable software for these needs?

Automatically translated from: Italiano

See original

Link copied

Reply

• • M

    MatteoF

    18.06.2024 at 11:46

    I’m new to the world of injection mold design and have been tasked with creating molds for a series of consumer electronics enclosures. I have experience with Autodesk Inventor, but I’m looking for a software solution that simplifies the mold design process, ideally able to automatically determine the positions of the ejection pins and design the entire mold base based on the part’s geometry. What is the most suitable software for these needs?

    Automatically translated from: Italiano

    See original

    0

    Reply
  • G

    Giuseppe Pestrin

    24.06.2024 at 10:15

    Good morning dear Matteo, unfortunately Xometry Europe does not design molds and we cannot give such advice. Many manufacturers work with Siemens NX/Catia software and use them to design molds. Moldex 3D or Autodesk Mold Flow are widely used software for process simulations. I hope these suggestions prove useful to you

    Automatically translated from: Italiano

    See original

    0

    Reply

    Link copied